Craftsman 917.27603 manual Engine OIL Filter, AIR Rlter, Muffler, Spark Plugs, Clean AIR Screen

ENGINE OIL FILTER

Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.

AIR RLTER

Your engine will not run properly using a dirty air filter. Clean the foam pre-cleaner after every 25 hours of operation or every season. Service paper cartridge every 100 hours of operation or every season, whichever occurs first.

Service air cleaner more often under dusty conditions.

1. Loosen knob and remove cover.

TO SERVICE PRE-CLEANER

2.Slide foam pre-cleaner off cartridge.

3.Wash it in liquid detergent and water.

4.Squeeze it dry in a clean cloth. Allow it to dry.

5.Saturate it in engine oil. Wrap it in clean, absorbent cloth and squeeze to remove excess oil.

TO SERVICE CARTRIDGE

•Replace a dirty, bent, or damaged car- tridge.

NOTE: Do not wash the paper cartridge or use pressurized air, as this will damage the cartridge.

1.Remove nut and cartridge plate.

2.Reinstall the pre-cleaner (cleaned and oiled) over the paper cartridge.

3.Check rubber seal for damage and proper position around stud. Replace if necessary.

4.Reassemble air cleaner, cartridge plate, and nut.

5.Reinstall air cleaner cover and secure by tightening knob.

Cartrid_

Foam

Pre-Cleaner

Cartridge

Plate _._,

Every 100 hours of operation (more often

under extremely dusty, dirty conditions), remove the blower housing and other cool- ing shrouds. Clean the cooling fins and external surfaces as necessary. Make sure the cooling shrouds are reinstalled.

NOTE: Operating the engine with a blocked grass screen, dirty or plugged cooling fins, and/or cooling shrouds removed will cause engine damage due to overheating.

MUFFLER

Inspect and replace corroded muffler and spark arrester (if equipped) as it could cre- ate a fire hazard and/or damage.

SPARK PLUG(S)

Replace spark plug(s) at the beginning of each mowing season or after every 100 hours of operation, whichever occurs

first. Spark plug type and gap setting are shown in "PRODUCT SPECIFICATIONS" section of this manual.

IN-LINE FUEL FILTER

The fuel filter should be replaced once each season. If fuel filter becomes clogged, obstructing fuel flow to carbu- retor, replacement is required.

1.With engine cool, remove filter and plug fuel line sections.

2.Place new fuel filter in position in fuel line with arrow pointing towards carbu- retor.

3.Be sure there are no fuel line leaks and clamps are properly positioned.

4.Immediately wipe up any spilled gaso- line.

Fuel Filter_

CLEANING

Knob

Rubber

Seal

Nut

•	Clean		engine,	battery, seat,		finish,	etc.
	of all foreign			matter.
•	Keep	finished		surfaces	and wheels		free
	of all	gasoline, oil, etc.
•	Protect		painted surfaces		with	auto-

CLEAN AIR SCREEN

Air screen must be kept free of dirt and chaff to prevent engine damage from overheating. Clean with a wire brush or compressed air to remove dirt and stub- born dried gum fibers.

CLEAN AIR INTAKE/COOLING AREAS

To insure proper cooling, make sure the grass screen, cooling fins, and other

external surfaces of the engine are kept clean at all times.

motive type wax.

We do not recommend using a garden hose or pressure washer to clean your tractor unless the engine and transmis- sion are covered to keep water out. Water in engine or transmission will shorten the useful life of your tractor. Use compressed air or a leaf blower to remove grass, leaves and trash from tractor and mower.

21