ENGINE
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers ex- pense, may be performed by any
engine repair establishment or individual. Warranty repairs must be performed by an authorized engine manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL
CABLE
The throttle control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as described below before loosening cable. If adjust- ment is necessary, proceed as follows:
1.With engine not running, move throttle control lever to fast position.
2.Check that swivel is against stop. If it is not, loosen cable clamp screw and pull cable back until swivel is against stop.
Tighten cable clamp screw securely.
TO ADJUST CHOKE CONTROL
The choke control has been preset at
the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjust- ment is necessary, proceed as follows:
1.With engine not running, move choke control (located on dash panel) to full choke position.
2.Loosen knob and remove cover as- sembly from air cleaner.
3.Choke should be closed. If it is not, loosen casing clamp screw and move
choke cable until choke is completely closed. Tighten casing clamp screw securely.
4.Replace air cleaner cover assembly and tighten knob.
TO ADJUST CARBURETOR
Your carburetor is not adjustable. If your engine does not operate properly due to
suspected carburetor problems, take your
tractor to a Sears or other qualified service center for repair and/or adjustment.
High speed stop is factory adjusted. Do
not adjust - damage may result.
IMPORTANT: Never tamper with the
engine governor, which is factory set for proper engine speed. Overspeed-
ing the engine above the factory high speed setting can be dangerous. If you
think the engine-governed high speed
needs adjusting, contact a Sears or other qualified service center,, which has proper
equipment and experience to make any
necessary adjustments.
SwivelClamp
Screw
\
\
Clamp ScrewI_
28
