Craftsman 917.276361 manual Transaxle Motion Control Le, Ver Neutral Adjustment, Ment

TRANSAXLE MOTION CONTROL LE-

VER NEUTRAL ADJUSTMENT

The motion control lever has been preset at the factory and adjustment should not be necessary.

1.Park Tractor on level surface. Stop tractor by turning ignition key to "OFF" position and engage parking brake.

2.Loosen the adjustment bolt in front of the right rear wheel.

3.Move motion control lever to the neu-

tral position.

4.Tighten the adjustment bolt.

Adjustment Bolt

TRANSMISSION REMOVAL/

REPLACEMENT

Should your transmission require removal for service or replacement, it should be purged after reinstallation and before op- erating the tractor. See "PURGE TRANS- MISSION" in the Operation section of this manual.

TO ADJUST STEERING WHEEL ALIGN-

MENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble with crossbars horizontal. Tighten securely.

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not

adjustable on your tractor. If damage has occurred to affect the front wheel toe-in or

camber, contact a Sears or other qualified service center.

TO REMOVE WHEEL FOR REPAIRS

FRONT WHEEL -

1.Block up axle securely.

2.Remove axle cover, retaining ring and washers to allow wheel removal.

3.Repair tire and reassemble.

4.Replace washers and snap retaining ring securely in axle groove.

5.Replace axle cover.

REAR WHEEL -

1.Block rear axle securely.

2.Remove five (5) hub bolts to allow wheel removal.

3.Repair tire and reassemble. Replace and tighten hub bolts securely.

NOTE: To seal tire punctures and prevent

flat tires due to slow leaks, purchase and use tire sealant from Sears. Tire sealant

also prevents tire dry rot and corrosion.

Washers

Retaining

Rinc

Axle

Cover

TO START ENGINE WITH A WEAK BAT- TERY

AI_WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from bat-

teries. Always wear eye protection when around batteries.

If your battery is too weak to start the

engine, it should be recharged. (See "BAT-

TERY" in the MAINTENANCE section of this manual).

If "jumper cables" are used for emergency starting, follow this procedure:

IMPORTANT: Your tractor is equipped with a 12 volt system. The other vehicle must also be a 12 volt system. Do not use your tractor battery to start other vehicles.

TO ATTACH JUMPER CABLES -

1.Connect one end of the RED cable to the POSITIVE (+) terminal of each battery(A-B), taking care not to short against tractor chassis.

2.Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

26