Keys | Slope Sheet |
(1) Oil Drain Tube
(2) Keys
Your new tractor has been assembled at the factory.
When right or left hand is mentioned in this manual, it means, from your point of view, when you are in the operating posi- tion (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
1.Cut along dotted lines on all four pan- els of carton. Remove end panels and lay side panels flat.
2.Remove packing materials.
3.Remove protective materials from trac- tor hood and grille.
IMPORTANT: Check for and remove any
staples in skid that may puncture tires where tractor is to roll off skid.
ADJUST SEAT
1.Raise seat and loosen adjustment knobs.
2.Lower seat into operating position and sit in seat.
3.Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.
4.Get off seat without moving its ad- justed position.
5.Raise seat and tighten adjustment knob securely.
CHECK BATTERY
1.Lift hood to raised position.
NOTE: If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at
,,?
| // | j Label |
• | - - i | j |
Adjustment
@@
NOTE: You may now roll or drive your
tractor off the skid. Follow the appropriate instruction below to remove the tractor
from the skid.
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
1.Press lift lever plunger and raise
attachment lift lever to its highest po- sition.
2.Release parking brake by depressing brake pedal.
3.Place freewheel control in transmission disengaged position (See "To Trans- port" in the Operation section of this manual).
4.Roll tractor forward off skid.
7
