ENGINE
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers ex- pense, may be performed by any
engine repair establishment or individual. Warranty repairs must be performed by an
authorized engine manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as described below before loosening cable. If adjust- ment is necessary, proceed as follows:
1.With engine not running, move throttle control lever from slow to choke posi- tion. Slowly move lever from choke to fast position.
2.Check to see if hole in throttle lever and hole in speed control bracket are aligned.
3.If holes are not aligned, loosen cable clamp screw and align the holes by inserting a pencil or a 1/4" drill bit
through both holes.
4.Pull throttle cable up to remove slack and tighten cable clamp screw. Re-
move alignment pencil or drill bit.
TO ADJUST CARBURETOR
The carburetor has been preset at the factory and adjustment should not be nec- essary. However, minor adjustment may be required to compensate for differences in fuel, temperature, altitude or load. If the carburetor does need adjustment, proceed as follows:
In general, turning the adjusting needles in (clockwise) decreases the supply of fuel to the engine giving a leaner fuel/air mixture. Turning the adjusting needles out
(counterclockwise) increases the supply
of fuel to the engine giving a richer fuel/air mixture.
IMPORTANT: Damage to the needles and seats in carburetor may result if turned in too tight.
NOTE: The carburetor on this engine is low emission. It is equipped with an idle fuel adjusting needle with a limiter cap, which allows some adjustment within the limits allowed by the cap. Do not attempt to remove the limiter cap. The limiter cap cannot be removed without breaking the adjusting needle.
1.Be sure you have a clean air filter and the throttle control cable is adjusted properly (see above).
2.Start engine and allow to warm for five minutes. Make adjustments with engine running and shift/motion control lever in neutral (N) position.
3.Idle speed setting - With throttle control lever in slow position, engine should idle at 1750 RPM. If engine idles too
slow or fast, turn idle speed adjusting screw in or out until correct idle is at-
tained.
4.Idle fuel needle setting - With throttle control lever in slow position, turn idle fuel adjustment needle in (clockwise) until engine begins to die and then turn
out (counterclockwise) until engine runs rough. Turn needle to a point midway between those two positions.
5.Recheck idle speed. Readjust if nec- essary.
ACCELERATION TEST -
6.Move throttle control lever from slow
to fast position. If engine hesitates or dies, turn idle fuel adjusting needle out
(counterclockwise) 1/8 turn. Repeat test and continue to adjust, if neces- sary, until engine accelerates smoothly.
High speed stop is factory adjusted. Do not adjust - damage may result.
IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeed- ing the engine above the factory high speed setting can be dangerous. If you
think the
Cable
Clam
Screw
Speed Control
Bracket
Idle Speed |
|
|
Adjusting_°- |
| / |
Screw | II |
|
Idle Fuel | II [__ |
|
Adjusting | LII_\ | I d/[[J ! |
Needle | /_ _H__'q_jJ;t_ | |
28
