TO CLEAN BATTERY AND TERMINALS
Corrosion and dirt on the battery and termi- nals can cause the battery to "leak" power.
1.Disconnect BLACK battery cable first then RED battery cable and remove battery from tractor.
2.Rinsethe battery with plain waterand dry.
3.Clean terminals and battery cable ends with wire brush until bright.
4.Coat terminals with grease or petro- leum jelly.
5.Reinstall battery (See "REPLACING BATTERY" in the SERVICE AND AD-
JUSTMENTS section of this manual).
TRANSAXLE COOLING
Keep transaxle free from
V-BELTS
Check
100 hours of operation and replace if neces- sary. The belts are not adjustable. Replace belts if they begin to slip from wear.
ENGINE
LUBRICATION
Only use high quality detergent oil rated
with API service classification
SAE VISCOSITY GRADES
F |
| 0 | 30 | 32 | 40 |
| 60 | 80 | 100 | |
i |
|
| i |
|
|
|
| i | i | i |
C |
|
| 0 |
| 1_0 | 20 | 30 | 40 |
TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
oilvisc chart1 e
NOTE: Although
oil consumption when used above 32°R Check your engine oil level more frequent- ly to avoid possible engine damage from running low on oil.
Change the oil after every 50 hours of op- eration or at least once a year if the tractor is not used for 50 hours in one year.
Check the crankcase oil level before starting the engine and after each eight (8) hours
of operation. Tighten oil fill cap/dipstick securely each time you check the oil level.
TO CHANGE ENGINE OIL
Determine temperature range expected
before oil change. All oil must meet API
service classification
•Be sure tractor is on level surface.
•Oil will drain more freely when warm.
•Catch oil in a suitable container.
1. Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine when changing oil.
2.Remove yellow cap from end of drain valve and install the drain tube onto the fitting.
3.Unlock drain valve by pushing inward slightly and turning counterclockwise.
4.To open, pull out on the drain valve. Oil Drain Valve
Closed
._Tube
Yellow Ca
5.After oil has drained completely, close and lock the drain valve by pushing inward and turning clockwise until the pin is in the locked position as shown.
6.Remove the drain tube and replace the cap onto the end of the drain valve.
7.Refill engine with oil through oil fill dip- stick tube. Pour slowly. Do not overfill.
For approximate capacity see "PROD-
UCT SPECIFICATIONS" section of this manual.
8.Use gauge on oil fill cap/dipstick for checking level. For accurate reading, insert dipstick into the tube and push down firmly into place before removing. Keep oil up to, but not over, the "FULl" line on dipstick. Push dipstick down firmly into the tube when finished.
ENGINE OIL FILTER
Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.
17
