To Adjust Choke Control, Replacing Battery

REPLACING BATTERY

m_nWARNING: Do not short battery ter- als by allowing a wrench or any other

object to contact both terminals at the same

time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected

first to prevent sparking from accidental grounding.

1.Lift seat pan to raised position.

2.Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

3.Install new battery with terminals in same position as old battery.

4.First connect RED battery cable to posi- tive (+) terminal with hex bolt and keps

nut as shown. Tighten securely. Slide terminal cover over terminal

5.Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely.

Seat Pan

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring dia- gram in the Repair Parts section.

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in

fuse. Thefuseholderislocated behindthedash.

TO REMOVE HOOD AND GRILL ASSEMBLY

1.Raise hood.

2.Unsnap headlight wire connector.

3.Stand in front of tractor. Grasp hood at sides tilttoward engine and lift offoftractor.

4.When replacing hood, be sure to re- connect the headlight wire connector.

Headlight Wire

Connector

Terminal

	. Keps
Cover	J Nut
"-(_.	Hex
	Bolt

Positive (Red)

CableNegative (Black) Cable

TO REPLACE HEADLIGHT BULB

1.Raise hood.

2.Remove bulb holder from the hole in the backside of the grill.

3.Replace bulb in holder and install bulb holder securely back into the hole in the backside of the grill.

4.Close hood.

ENGINE

TOADJUSTTHROTTLE CONTROLCABLE

The throttle control has been preset at

the factory and adjustment should not be necessary Check adjustment as described below before loosening cable. If adjustment is necessary, see engine manual.