TOCHECKBRAKE
Iftractorrequiresmorethanfive(5)feetto stopathighestspeedinhighestgearona
level,dryconcreteorpavedsurface,then
brakemustbeserviced.
Youmayalsocheckbrakeby:
1.Parktractoronalevel,dryconcreteor
pavedsurface,depressbrakepedal allthewaydownandengageparking brake.
2.Disengagetransmissionbyplacing freewheelcontrolin"transmissiondis- engaged"positionPuttfreewheelcon.- troloutandintotheslotandreleaseso
itisheldinthedisengagedposition. Therearwheelsmustlockandskid whenyoutrytomanuallypushthetractor forwardIftherearwheelsrotate,thenthe. brakeneedstobeservicedContact. Searsorotherqualifiedservicecenter.
FRONT WHEEL TOE=IN/CAMBER
Your new tractor front wheel
camber is set at the factory and is normal. The front wheel
not adjustable. If damage has occurred to affect the factory set front wheel
camber, contact a Sears or other qualified service center.
TO REMOVE WHEEL FOR REPAIRS
1.Block up axle securely.
2.Remove axle cover, retaining ring and washers to allow wheel removal (rear wheels have a square key - Do not lose).
3.Repair tire and reassemble.
NOTE: On rear wheels only: align
grooves in rear wheel hub and axle. Insert square key.
4.Replace washers and snap retaining ring securely in axle groove.
5.Replace axle cover.
NOTE: To seal tire punctures and prevent
flat tires due to stow leaks, purchase and use tire sealant from Sears. Tire sealant
also prevents tire dry rot and corrosion.
Washers
Retaining
Ring X
o
Axle Cover
_Square Key (Rear
Wheel Only)
TO START ENGINE WITH A WEAK BAT=
TERY
_,WARNING:
If your battery is too weak to start the
engine, it should be recharged. (See "BAT- TERY" in the MAINTENANCE section of
this manual).
If "jumper cables" are used for emergency starting, follow this procedure: IMPORTANT: Your tractor is equipped with a 12 volt system. The other vehicle must also be a 12 volt system. Do not use your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES -
1.Connect one end of the RED cable
to the POSITIVE (+) terminal of each
2.Connect one end of the BLACK cable to the NEGATIVE
3.Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.
TO REMOVE CABLES, REVERSE ORDER -
1.BLACK cable first from chassis and then from the fully charged battery.
2.RED cable last from both batteries.
26