
[he operationof any lawnmowercan esultin foreignobjectsthrownintothe _yes,whichcanresultin severeeyedam- _ge.Alwayswearsafetyglassesor eye _hieldswhileoperatingyourlawnmoweror )efforminganyadjustmentsor repairs..We
ecommea,d awidevisionsafetymaskover :hespectaclesor standardsafetyglasses.
:4OW TO USE YOUR LAWN MOWER
ENGINE SPEED CONTROL
the engine speed was set at the factor,]
:or optimum performance° Speed is not _djustable.
ENGINE ZONE CONTROL
C,AUTiON: Federal regulations require _n engine control to be installed on this awn mower in order to minimize the isk of blade contact injury. Do not un-
:ler any circumstances attempt to
,Your lawn mower is equipped with an operator presence control bar which requires the operator to be positioned behind the lawn mower handle to start
and operate the lawn mower,. ro ADJUST CUTTING HEIGHT
,Raise wheels for low cut and lower wheels for high cut,.
,Adjust cutting height to suit your require- ments., Medium position is best for most lawns,.
,To change cutting height, squeeze adjuster lever toward wheel,. Move wheel up or down to suit your requirements.. Be sure all wheels are in the same setting.
NOTE: Adjuster is properly positioned
_vhen plate tab inserts into hole in lever. _,lso,
allow lever to be positioned between the 3late tab&
Lower Wheels for High Cut Plate
DRIVE CONTROL
o
o Forward motion will stop when the opera- tor presence control bar is released° To stop forward motion without stopping engine, release the operator presence control bar slightly until the drive control
disengages. Hold operator presence control bar down to handle to continue
mowing without
o To keep drive control engaged when turning comers, push down on handle and lift front wheels off ground while turn- ing lawn mower,
Operator presence control bar Drive con-
To engage ('_k_% _ | _rive control |
drive control | disengaged |
TO INSTALL DISCHARGING
DEFLECTOR
o Lift door upward on it'shinge until the deflector frame can be hooked over the door mounting bracket as shown°
o Release the door to rest against deflec- tor frame,.
o To return to mulching operation, reverse the above steps and be sure door is in
closed position°
Mulcher Door
Deflector
Raise | _,_ | ver |
Wheels for |
| |
Low Cut |
|
|
7