Read these instructions and this manual in its entirety before you attempt to assemble or operate your new lawn
mower.
IMPORTANT: This lawn mower is
shipped WITHOUT OIL OR GASOLINE in
the engine.
Your new lawn mower has been as- sembled at the factory with the exception of those parts left unassembled for shipping purposes. All parts such as nuts, washers, bolts, etc., necessary to com- plete the assembly have been placed in the parts bag. To ensure safe and proper operation of your lawn mower, all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.
TO REMOVE LAWN MOWER FROM
CARTON
1.Remove loose parts included with mower.
2.Cut down two end corners of carton and lay end panel down flat,
3.Remove all packing materials except padding between upper and lower handle and padding holding operator presence control bar to upper handle.
4.Roll lawn mower out of carton and check carton thorougly for additional loose parts,
HOWTO SET UPYOUR LAWN MOWER
TO UNFOLD HANDLE
IMPORTANT: Unfold handle carefully so as not to pinch or damage control cables.
1.Raise handles until lower handle section rocks into place in mowing position.
2.Remove protective padding, raise upper handle section into place on lower handle and tighten both handle knobs.
3.Remove handle padding holding
operator presence control bar to upper handle.
Your lawn mower handle can be adjusted for your mowing comfort. Refer to "Adjust Handle" in the Service and Adjustments section of this manual.
OP_r'a;°braPresence_Lift u[_)
Upperhandle-_ _" /#"
•.o0
Lower handle
5
