Craftsman 917.37841 To Adjust Handle, To Assemble Grass Catcher, Engine Engine Speed, Carburetor

Models: 917.37841

1 27
Download 27 pages 41.15 Kb
Page 14
Image 14

TO ADJUST HANDLE

The upper handle may be adjusted to four (4) different height positions.

1.

Loosen both handle knobs only

 

 

enough to allow the upper handle to

 

 

pivot to the desired adjustment

CatmC;eha_d_

 

position.

 

 

2.

Tighten both handle knobs securely.

 

Handle Knob

Handle Knob

TO ASSEMBLE GRASS CATCHER

1.Put grass catcher frame into grass bag

with rigid part of bag on the bottom. Make sure the frame handle is outside

of the bag top.

2.Slip vinyl bindings over frame.

NOTE: If vinylbindings are too stiff, hold them in warm water for a few minutes. If

bag gets wet, let it dry before using.

ACAUTION: Do not run your lawn mower without clipping deflector or approved grass catcher in place. Never attempt to operate the lawn mower with the rear door removed or propped open.

Immediately prepare your lawn mower for storage at the end of the season or if the unit will not be used for 30 days or more.

LAWN MOWER

When lawn mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire lawn mower (See "CLEANING" in the Maintenance section of this manual).

2.Lubricate as shown in the Mainte- nance section of this manual.

3.Be sure that all nuts, bolts, screws, and pins are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

oF'; o

ENGINE

ENGINE SPEED

Your engine speed has been factory set.

Do not attempt to increase engine speed or it may result in personal injury. If you believe that the engine is running too fast or too slow, take your lawn mower to a Sears or other qualified service center for repair and adjustment.

CARBURETOR

Your carburetor has a non-adjustable fixed main jet for mixture control. If your

engine does not operate propedy due to suspected carburetor problems, take your lawn mower to a Sears or other qualified

service center for repair and/or adjust- ment.

IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed setting can be dangerous. If you think the engine-governed high speed needs

adjusting, contact a Sears or other qualified service center, which has proper equipment and experience to make any necessary adjustments.

4.Touch up all rusted or chipped paint surfaces; sand lightly before painting.

HANDLE

You can fold your lawn mower handle for storage.

1.Squeeze the bottom ends of the lower handle toward each other until the lower handle clears the handle bracket, then move handle forward.

2.Loosen upper handle mounting bolts enough to allow upper handle to be folded back.

IMPORTANT: When folding the handle

for storage or transportation, be sure to fold the handle as shown or you may damage the control cables.

14

Page 14
Image 14
Craftsman 917.37841 owner manual To Adjust Handle, To Assemble Grass Catcher, Engine Engine Speed, Carburetor