_CAUTION: Before performing any service or adjustments:
1.Release control bar and stop engine.
2.Make sure the blade and all moving parts have completely stopped.
3.Disconnect spark plug wire from spark plug and place where it cannot come in contact with plug.
LAWN MOWER
TO ADJUST cu'n'ING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in
the Operation section of this manuat.
REAR DEFLECTOR
The rear deflector, attached between the rear wheels of your mower, is provided to
minimize the possibility that objects will be thrown out of the rear of the mower
into the operator mowing position. If the deflector becomes damaged, it should be reptaced.
TO REMOVE/REPLACE DRIVE BELT
1.Remove drive cover. Remove belt
from gearcase pultey by pushing down on pulley and rotting belt off it.
2.Turn lawn mower on its side with air fitter and carburetor up.
3.Remove blade.
4.Remove debris shield.
5.Remove belt from engine pulley on crankshaft.
6.Install new belt by reversing above steps.
7.Always use factory approved belt to assure fit and long life.
TO ADJUST HANDLE
The handle can be mounted in a high or low position. The mounting holes in the bottom of lower handle are off center for
raising or towering the handle.
1.Remove upper handle and all parts attached to lower handle.
2.Remove hairpin cotters from lower handle bracket mounting pin.
3.Squeeze lower handle in to remove it from mounting pins.
4.Turn lower handle over to raise or lower handle.
5.Squeeze lower handle in and position holes onto mounting pins on handle bracket.
6.Reassemble upper handle and all parts removed from lower handle.
Lower handle
Rotate
Drive Befl
cover
15
