DRIVE CONTROL
•
•Forward motion will stop when the operator presence control bar is released. To stop forward motion without stopping engine, release the operator presence control bar slightly until the drive control disengages. Hold operator presence control bar down against handle to continue mowing without
•To keep drive control engaged when turning comers, push down on handle and lift front wheels off ground while turning lawn mower.
Operator presence control bar
\x
To engage | Drive control |
drive control | disengaged |
ADD GASOLINE
NOTE: Before filling fuel tank, remove
and discard the debris plug that is inside the tank.
•Fill fuel tank. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. Do not mix oil with gaso- line. Purchase fuel in quantities that
can be used within 30 days to assure fuel freshness.
_WARNING: Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.
ACAUTION: Fill to bottom of gas tank
filler neck. Do not overfill. Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.
Gasoline | • | • |
BEFORE STARTING ENGINE
ADD OIL
Your lawnmower is shipped without oil in the engine. Engine holds 20 oz. of oil.
For type and grade of oi! to use, see "ENGINE" in Maintenance section of this
manual.
1.Be sure lawnmower is level and area around oil fill is clean.
2.Remove engine oil cap and fill to the full line on the dipstick. Pour oil slowly. Do not over fill.
NOTE: Allow oil to settle down into engine for accurate dipstick reading. To read proper level, tighten engine oil cap, then remove it to read the dipstick.
3.Reinstall engine oil cap and tighten.
• Check oil level before each use. Add oil if needed. Fill to full line on dipstick.
• Change the oil after every 25 hours of operation or each season. You may need to change the oil more often under dusty, dirty conditions.
filler cap_ | EngIneodcap |
(Discard debris plug
inside) __'_
TO START ENGINE
NOTE: Due to protective coatings on the engine, a small amount of smoke may be present during the initial use of the product and should be considered normal.
1.To start a cold engine, push primer three (3) times before trying to start. Use a firm push. This step is not usually necessary when starting an
engine which has already run for a few minutes.
2.Move handle mounted throttle control lever to fast position.
3.Hold operator presence control bar down to the handle.
4.Turn electric start key clockwise to
9 crank engine.
