TROUBLESHOOTINGCHART
PROBLEMCAUSE
Starter | rope hard | 1. | Engine flywheel | brake is on | |
to pull |
|
| when control bar is release_ | ||
|
| 2. | Bent engine crankshaft, | ||
|
| 3. | Blade adapter | broken. | |
|
| 4. | Blade dragging | in grass. | |
Grass | catcher | 1. | Cutting height too low. | ||
rtotfllllng(ifeo | 2. | Lift on blade worn off. | |||
_luipped) | 3. | Catcher | not venting air, | ||
Nard to push | 1. | Grass is too high or wheel | |||
|
|
| height is too low. | ||
|
| 2. | Rear of lawn mower | ||
|
|
| housing or blade dragging | ||
|
|
| in grass. |
| |
|
| 3. | Grass catcher too full. | ||
|
| 4. | Handle | height position not | |
|
|
| right for | you. |
|
17
CORRECTION
1.Depress control bar to upper handle before pulling starter rope.
2.Contact a Sears or other qualified service center.
3.Replace blade adapter.
4.Move lawn mower to cut grass or to hard surface.
1.Raise cutting height.
2.Replace blade.
3.Clean grass catcher.
1.Raise cutting.height,
2.Raise rear of lawn mower
housing one (1) setting higher.
3.Empty grass catcher.
4.Adjust handle height to suit.
