Craftsman 917.38885 Other, Engine Oil, Cylinder, Problem, Cause, Correction, Does not start

Models: 917.38885

1 18
Download 18 pages 35.15 Kb
Page 16
Image 16

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Maintenance section of this manual).

CYLINDER

1.Remove spark plug.

2.Pour one ounce (29 ml) of oil through spark plug hole into cylinder.

3.Pull starter handle slowly a few times to distribute oil.

4.Replace with new spark plug.

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your unit indoors and cover it to protect it from dust and dirt.

Cover your unit with a suitable protec- tive cover that does not retain moisture. Do not use plastic. Plastic cannot breathe, which allows condensation to form and will cause your unit to rust.

IMPORTANT: Never cover mower while engine and exhaust areas are still warm.

ENGINE OILCAUTION: Never store the lawn mower with gasoline in the tank inside a building where fumes may reach an open fl ame or spark. Allow the engine to cool before storing in any enclosure.

TROUBLESHOOTING - See appropriate section in manual unless directed to a Sears Parts & Repair Center.

PROBLEM

 

CAUSE

CORRECTION

Does not start

1.

Dirty air fi lter.

1.

Clean/replace air fi lter.

 

2.

Out of fuel.

2.

Fill fuel tank.

 

3.

Stale fuel.

3.

Empty fuel tank and refi ll tank

 

 

 

 

with fresh, clean gasoline.

 

4.

Water in fuel.

4.

Empty fuel tank and refi ll tank

 

 

 

 

with fresh, clean gasoline.

 

5.

Spark plug wire is

5.

Connect wire to plug.

 

 

disconnected.

 

 

 

6.

Bad spark plug.

6.

Replace spark plug.

 

7.

Loose blade or broken

7.

Tighten blade bolt or

 

 

blade adapter.

 

replace blade adapter.

 

8.

Control bar in released

8.

Depress control bar to

 

 

position.

 

handle.

 

9.

Control bar defective.

9.

Replace control bar.

 

10. Fuel valve lever (if so

10. Turn fuel valve lever

 

 

equipped) in OFF position.

 

to the ON position.

 

11. Weak battery (if equipped).

11. Charge battery.

 

12. Disconnected battery

12. Connect battery to engine.

 

 

connector (if equipped).

 

 

 

 

 

 

 

16

Page 16
Image 16
Craftsman 917.38885 owner manual Other, Engine Oil, Cylinder, Problem, Cause, Correction, Does not start