AIR FILTER
Yourenginewill notrunproperlyusinga
dirty air filter. Clean the foam
Service air cleaner more often under dusty conditions.
• | Remove knob(s) and | cover. |
TO SERVICE | ||
° | Slide foam | off cartridge. |
= | Wash it in liquid detergent and water |
ENGINE COOLING FINS
Remove any dust, dirt or oil from engine cooling fins to prevent engine damage from overheating.
o Remove screws from blower housing and lift housing and dipstick tube assembly off engine.
o Cover oil fill opening to prevent entry of dirt.
=Use compressed air or stiff bristle brush to thoroughly clean engine cooling fins.
o To reassemble, reverse above proce- dure.
o Squeeze it dry in a clean cloth. |
o Saturate it in engine oil. Wrap it in clean, |
absorbent cloth and squeeze to remove |
excess oito |
o If very dirty or damaged, replace pre- cleaner°
o Reinstall
Screws
Blower Housing Screws
air screen
•Reinstall cover and secure with knob(s).
TO SERVICE CARTRIDGE
=Remove cartridge nut.
*Carefully remove cartridge to prevent debris from entering carburetor° Clean base carefully to prevent debris from
entering carburetor.
,, Clean cartridge by tapping gently on flat surface. If very dirty or damaged, replace cartridge.
o Reinstall cartridge, nut, precleaner, cover and secure with knob(s).
IMPORTANT: Petroleum solvents, such as kerosene, are not to be used to clean the cartridge. They may cause deterioration of the cartridge. Do not oil cartridge. Do not use pressurized air to clean or dry car- tridge.
Cover
Knob
Cartridge
Cover
Paper
Cartridge
Foame
_Base
DipstickTube
Assembly
Spark
Plug
Engine Cooling
MUFFLER
Inspect and replace corroded muffler and spark arrester (if equipped) as it could cre-
ate a fire | hazard and/or damage_ | _ |
SPARK | PLUGS | ": ..... _,:: |
Replace spark plugs at the beginning of .''_" each mowing season or after every 100 _ hours of operation, whichever occurs first.
Spark plug type and gap setting are shown in "PRODUCT SPECIFICATIONS"
on page 5 of this manual.
The fuel filter should be replaced once each season, if fuel filter becomes
clogged, obstructing fuel flow to carbure- tor, replacement is required.
o With engine cool, remove filter and plug fuel line sections.
o Place new fuel filter in position in fuel line with arrow pointing towards carbu- retor.
o Be sure there are no fuel line leaks and clam.ps are properly positioned.
21