repairs,,We recommendawidevisionsafetymaskover thespectacles,or standardsafetyglasses.
HOW TO USE YOUR TRACTOR
Your tractor is equipped with an operator presence sensing switch,, When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine,.
TO SET PARKING BRAKE
o Depress clutch/brake pedal into full "BRAKE" position and hold.
•Place parking brake lever in "EN- GAGED" position and release pressure from clutch/brake pedal,, Pedal should remain in "BRAKE" position. Make sure parking brake will hold tractor secure,,
|
|
| Attachment Clutch |
Throttle/Choke |
|
| Lever "Engaged" |
Controt |
|
| Position |
| "" |
| "Disengaged" |
.,,__.<. |
|
| ..Position |
"Brake" | I _ |
| Parking Brake |
Position___ | ' |
| "Engaged" |
_Z | _ | Position |
Pedal "Drive .... Disengaged" Control
Position PositionLever
STOPPING
MOWER BLADES -
o To stop mower blades, move attach- ment clutch Lever to "DISENGAGED"
position.
GROUND DRIVE-
o To stop ground drive, depress clutch/brake pedal into full "BRAKE" po_ sitiono
o Move motion control lever to neutral (N)
position.
IMPORTANT: The motion control lever does not return to neutral (N) position when the clutch/brake pedal is depressed.
ENGINE -
o Move throttle control to slow position,,
NOTE: Failure to move throttle control to slow position and allowing engine to idle before stopping may cause engine to "backfire".
. Turn ignition key to "OFF" position and remove key_ Always remove key when leaving tractor to prevent unauthorized use.
o Never use choke to stop engine,, NOTE: Under certain conditions when tractor is standing idle with the engine run- ning, hot engine exhaust gases may cause "browning" of grass,, To eliminate this possibility, always stop engine when
pping tractor on grass areas,, CAUTION: Always stop tractor com-
pletely, as described above, before leaving the operator's position, to empty grass catcher, etc.
THROTTLE CONTROL
Always operate engine at full throttle.
o Operating engine at less than full throt- tle reduces the battery charging rate,,
o Full throttle offers the best bagging and mower performance,,
TO MOVE FORWARD AND BACKWARD
The direction and speed of movement is
controlled by the motion control lever,
o Start tractor with motion control lever in
neutral (N) position.
o Release parking brake and clutch/brake
pedal.
o Slowly move motion control lever to desired position.
TO ADJUST MOWER CUTTING HEIGHT The position of the attachment lift lever determines the cutting height,,
° Grasp lift lever°
o Press plunger with thumb and move lever to desired position.
The cutting height range is approximately
o The average lawn should be cut to approximately
13