•The average lawn should be cut to ap- proximately
•For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut relatively high; the second to desired height.
TO OPERATE MOWER
Your tractor is equipped with an operator presence sensing switch. Any attempt
•by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.
1.Select desired height of cut.
2.Start mower blades by engaging at- tachment clutch control.
TO STOP MOWER BLADES -
disengage attachment clutch control.
_b,CAUTION: Do not operate the mower
without either the entire grass catcher, on mowers so equipped, or the deflector
shield in place.
|
| Lift |
| Lever | High Position |
Attachmenl | zl- |
|
Clutch Lever |
|
|
"En | Low | |
|
| Position |
Position | _. | |
"Disengaged" | ||
Shield
TO OPERATE ON HILLS
,_kWARNING: Do not drive up or down hills with slopes greater than 15 ° and do not drive across any slope. Use the slope guide at the back of this manual.
•Choose the slowest speed before start- ing up or down hills.
•Avoid stopping or changing speed on hills.
•If slowing is necessary, move throttle control lever to slower position.
•If stopping is absolutely necessary, push clutch/brake pedal quickly to brake posi- tion and engage parking brake.
•Move gearshift lever to 1st gear. Be sure you have allowed room for tractor to roll slightly as you restart movement.
•To restart movement, slowly release parking brake and clutch/brake pedal.
•Make all turns slowly.
TO TRANSPORT
•Raise attachment lift to highest position with attachment lift control.
•When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position.
•Do not push or tow tractor at more than
five (5) MPH.
NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).
TOWING CARTS AND OTHER ATTACH- MENTS
Tow only the attachments that are recom- mended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.
BEFORE STARTING THE ENGINE
CHECK ENGINE OIL LEVEL
The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.
1.Check engine oil with tractor on level ground.
2.Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, re- move and read oil level. If necessary, add oil until "FULL" mark on dipstick is reached. Do not overfill.
•For cold weather operation you should change oil for easier starting (See the oil viscosity chart in the Maintenance section of this manual)•
•To change engine oil, see the Mainte- nance section in this manual.
14
