Engine
Center
Clutching
Keeper
Stationary Idler
Transaxle
TRANSAXLE GEAR SHIFT LEVER NEU- TRAL ADJUSTMENT
The transaxle should be in neutral when the gear shift lever is in neutral (N) (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows:
1.Make sure transaxle is in neutral (N). NOTE: When the tractor rear wheels move
freely, the transaxle is in neutral.
2.Loosen adjustment bolt in front of the right rear wheel.
3.Position the gear shift lever in the neu- tral (N) position.
4.Tighten adjustment bolt securely. NOTE: If additional clearance is needed
to get to adjustment bolt, move mower deck height to the lowest position.
GI | Neutral Lock Gate |
|
TO ADJUST STEERING WHEEL ALIGN- MENT
If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble with crossbars
horizontal. Tighten securely.
FRONT WHEEL TOE-IN/CAMBER
The front wheel toe-in and camber are not
adjustable on your tractor. If damage has occurred to affect the front wheel
camber, contact a Sears or other qualified service center.
TO REMOVE WHEEL FOR REPAIRS
1.Block up axle securely.
2.Remove axle cover, retaining ring and washers to allow wheel removal (rear wheels have a square key - Do not lose).
3.Repair tire and reassemble.
NOTE: On rear wheels only: align
grooves in rear wheel hub and axle. Insert square key.
4.Replace washers and snap retaining ring securely in axle groove.
5.Replace axle cover.
NOTE: To seal tire punctures and prevent flat tires due to slow leaks, purchase and use tire sealant from Sears. Tire sealant
also prevents tire dry rot and corrosion.
Washers
Retaining
Rin(
Axle
Cover
I
Square Key f
(Rear Wheel Only)
TO START ENGINE WITH A WEAK BAT-
TERY
_,WARNING:
If your battery is too weak to start the
engine, it should be recharged. (See "BAT- TERY" in the MAINTENANCE section of
this manual).
If "jumper cables" are used for emergency starting, follow this procedure: IMPORTANT: Your tractor is equipped with a 12 volt system. The other vehicle must also be a 12 volt system. Do not use your tractor battery to start other vehicles.
TO ATTACH JUMPER CABLES -
1.Connect one end of the RED cable to the POSITIVE (+) terminal of each
2.Connect one end of the BLACK cable to the NEGATIVE
fully charged battery.
3_ Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.
24