TO REMOVE WHEEL FOR REPAIRS
FRONT WHEEL (See Fig°29)
°Block up axle securely_
oRemove axle cover, retaining ring and washersto ailow wheel removal.
°Repair tire and reassemble.
oReplace washers and snap retaining ring securely in axle groove.
•Replace axle cover.
WASHERS
RETAINING
AXLE
COVER
FIG. 29
REAR WHEEL -
,,Block rear axle securely.
°Remove five (5) hub bolts to allow wheel removal.
°Repair tire and reassemble. Replace and tighten hub bolts securely.
TO START ENGINE WITH A WEAK BATTERY
(See Fig. 30)
CAUTION:
ateexplosive gases. Keepsparks, flame
and smoking materials away from bat- I teries. Always wear eye protection
when around batteries.
II
if your battery is too weak to start the engine, it should be
recharged° If "jumper cables" are used for emergency starting, follow this procedure:
IMPORTANT: YOUR TRACTOR tS EQUIPPED WiTH A 12 VOLT NEGATIVE GROUNDED SYSTEM THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES
TO ATTACH JUMPER CABLES -
°Connect each end of the RED cable to the POSITIVE
(+)terminal of each battery, taking care not to short against chassis,.
•Connect one end of the BLACK cable to the NEGA- TIVE (_)terminal of fully charged battery,
°Connect the other end of the BLACK cable to a panel bolt on the left side of the tractor, away from fuel tank and battery
TO REMOVE CABLES, REVERSE ORDER -
°BLACK cable first from chassis and fully charged battery.
,RED cable last from both batteries,.
"POSITIVE" (+) | "NEGATIVE" |
L.H.
PANEL
BOLT
FIG. 30
TO REPLACE HEADLIGHT BULB
°Raise hoo&
°Pul! bulb holder out of the hole in the backside of the grill.
°Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill
•Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.
°Checkwiring_ See electrical wiring diagram in Repair Parts section of this manual.
TO REPLACE FUSE
Replace with 30 amp
23
