GLOSSARY

Become familiar with these terms before operating the unit.

CFM: Cubic feet per minute.

SCFM: Standard cubic feet per min- ute; a unit of measure of air delivery. PSIG: Pounds per square inch gauge; a unit of measure of pressure.

Code Certification: Products that bear one or more of the following marks: UL, CUL, ETL, CETL, have been evaluated by OSHA certified independent safety laboratories and meet the applicable Underwriters Laboratories Standards for Safety. Cut-In Pressure: While the motor is off, air tank pressure drops as you

continue to use your accessory. When the tank pressure drops to a certain low level the motor will restart auto- matically. The low pressure at which the motor automatically restarts is called "cut-in" pressure.

Cut-Out Pressure: When an air com- pressor is turned on and begins to run, air pressure in the air tank begins to build. It builds to a certain high pressure before the motor automati- cally shuts off, protecting your air tank from pressure higher than its capacity. The high pressure at which the motor shuts off is called "cut-out" pressure.

Branch Circuit: Circuit carrying elec- tricity from electrical panel to outlet.

ACCESSORIES

This unit is capable of powering the following accessories. The accessories are available through the current Power and Hand Tool Catalog or full-line Sears stores.

Accessories

In Line Filter

Tire Air Chuck

Quick Connector Sets

(various sizes)

Air Pressure Regulators

Oil Fog Lubricators

Air Hose: 1/4", 3/8" or 1/2" I.D. in various lengths

Refer to the selection chart located on the unit to select the tools this unit is capable of powering.

The use of any other accessory

not recommended for use with this tool could be hazardous. Use only accessories rated equal to or higher than the rating of the air compressor.

duty cycle

This air compressor pump is capable

average duty cycle be maintained;

of running continuously. However, to

that is, the air compressor pump

prolong the life of your air compressor,

should not run more than 30-45

it is recommended that a 50%-75%

minutes in any given hour.

9 - ENG

N014212

Page 9
Image 9
Craftsman 919.15216 owner manual Glossary, Accessories