ACCESSORIES FOR USE WiTH SEARS COMPRESSORS
The following accessories are available through the current general sales catalog orat fuliqJneSears stores.
,SPRAY GUNS
°BLOW GUNS
oAIRCAULKING GUNS
oAIRPOWERED WASHER GUNS
,SAND BLASTERS
°AIR BRUSHES
oAIRLINE FILTERS
oTIRE AIR CHUCKS
.PAINT TANKS
oAIRTANKS
•INFLATOR KITS
oQUICKCONNECTOR SETS
(various sizes)
oVISCOSIMETER
,AIR PRESSURE REGULATORS
oOILFOG LUBRICATORS
,AIR TOOLS:
Sanders
Drills
Impact wrenches
Hammers
,AIR HOSE:
1/4", 5/16" OR 3/8" LD.
in various lengths.
GENERAL
Youhave purchased an air compressor unitconsisting of
a 2 cylinder, single stage air compressor pump, an air
tank, air hose, wheels, handte, air chuck andassociated
controls.
Your air compressor can be used for operating paint
spray guns, air tools, caulking guns, grease guns, air
brushes, sandblasters, power washers, inflating tires
and plastic toys, spraying weed killers, insecticides, etc.
An air line filter is usually required for removal ofmois-
ture and oil vapor incompressed air when a paint spray
gun is used.
iNFORMATiON
An in-line lubricator is usually required for air tools to
prolong toot life.
Separate air transformers which combine the functions
ofair regulation and/or moisture and dirt removal should
be used where applicable.
These accessories can be purchased from most Sears
stores or through the Sears General catatog or Power
Tootcatalog.
VALVE
VALVE
)RAIN
VALVE
Air Compressor Pump: To compress air, the pistons
move up and down in the cylinders. On the downstroke,
air is drawn in through the air intake filter and then
through the air intake valves.The exhaust valve remains
closed. On the upstroke of the piston, air is compressed.
The intake valves close and compressed air is forced
out through the exhaust valve, through the outlet tube,
through the check vatve and into the air tank. Working air
is not available until the compressor hasraised air tank
pressure above that required at the air outlet.
Check Vatve: When the aircompressor is operating, the
check valve is "open", allowing compressed air to enter
the air tank. When theair compressor reaches "cut-out"
pressure, the check vaIve "closes", aJlowing airpressure
to remain inside the air tank.
Pressure RemeaeeValve:The pressure release valve
located on the side ofthe pressure switch, is designed to
automatically release compressed air from the com-
pressor head and the outlet tube when the air compres-
sor reaches "cut-out" pressure or is shut off. If the airis
notrelease& the motorwilt tryto start, but will be unable
to. The pressure release vatve allows the motor to re-
start freely. When the motor stops running, air wilt be
heard escaping from the valvefor a fewseconds. No air
should be heard leaking fromthe valve when the motor is
running.
Safety Valve:tfthe pressure switch does not shut off the
air compressor ator nearits cut-out pressure setting, the
safety valve will protect against high pressure by "pop-
ping out" at itsfactory-.set pressure (slightJy higher than
the pressure switch cut-out setting).