Pressure Washer Maintenance
Check and Clean Inlet Screen: Examine inlet screen
on pump inlet fitting. Clean if clogged; replace if torn.
Check High Pressure Hose: High pressure hose can develop leaks from wear, kinking, abuse. Inspect hose each time before use. Check for cuts, leaks, abrasions or bulging of cover, and damage or movement of couplings. If any of these conditions exist, replace hose immediately.
Check Chemical/Soap Hose: Examine the chemical/ soap hose and clean if clogged. Hose should fit tightly on pump fitting. Check for leaks and tears. Replace filter or hose if either is damaged.
Check Gun and Wand: Examine hose connection to
gun making sure it is secure. Test trigger by pressing it and making sure it springs back into place when you release it.
Pump Maintenance (Changing Pump Oil)
The pump on your pressure washer was shipped from the factory with oil. The oil in your pump must be changed every 50 hours.
•Run engine until it runs out of fuel. Otherwise, fuel can leak out, creating a fire/explosion hazard, when you tip engine.
•Disconnect spark plug wire and keep it away from spark plug.
•Drain engine oil. See Changing Oil on page 8.
_CAUTION: | Used oil is a hazardous waste |
product. Dispose of used oil properly. Do not discard with household waste. Check with your local authorities for safe disposal/recycling
faci t es.
•Using a 5/16" Allen wrench remove pump oil drain plug.
Oil Drain Plug
•Tilt unit and drain pump oil into appropriate container.
•Fill pump with 8 ounces of R&O 150 oil. NOTE: tf unable to find R&O 150 oil, use 30W
•Replace oil drain plug and tighten securely.
•Refill engine with oil and fuel. See Engine Oil on page 8.
Purge Pump of Air and Contaminants
To remove the air from the pump, follow these
steps:
•Set up the pressure washer as described in ASSEMBLY section and connect the water supply.
•Remove the wand extension from the spray gun.
•Pull the trigger on the gun and hold.
To remove the contaminants from the pump, follow these steps:
•Set up the pressure washer as described in ASSEMBLY section, connect the water supply.
•Remove the wand extension from the spray gun.
•Start the engine according to instructions in the OPERATION section.
•Pull the trigger on the gun and hold.
•When the water supply is steady and constant, disengage trigger and refasten the wand exten- sion.
Engine Maintenance
Check Oil Level
•Oil level should be checked prior to each use or at least every 5 hours of operation. To check oil see Engine Oil on page 8.
ce059eRev0 3_1_ce |
