ASSEMBLY
Contents of Carton
1 - Air Compressor
1 - Parts bag containing:
1 - Operator’s Manual
1 - Parts Manual
4 - 5/8" Washers
Tools Required for Assembly
1 - 9/16" socket or open end wrench
Electric drill
Unpacking
1.Remove all packaging.
It may be necessary to brace
or support one side of the outfit when removing the pallet because the air compressor will have a tendency to tip.
2.Remove and discard the (4) screws and washers holding the compressor to the pallet.
3.With the help of another person carefully remove air compressor from pallet and place on a level surface.
INSTALLATION
HOW TO SET UP YOUR UNIT
Location of the Air Compressor
•Locate the air compressor in a clean, dry, and well ventilated area.
•Located the air compressor at least 12" away from the wall or other obstructions that will interfere with the flow of air.
•Locate the air compressor as close to the main power supply as possible to avoid using long lengths of electrical wiring. NOTE: Long lengths of electrical wiring could cause power loss to the motor.
•The air filter must be kept clear of obstructions which could reduce air flow to the air compressor.
Anchoring of the Air
Compressor
Excessive Vibration can weaken the air
tank and cause an explosion. The compressor must be properly mounted.
The air compressor MUST be bolted
to a solid, level surface. Hardware needed:
4 - Concrete anchors
4 - 3/8" Lag screw to fit concrete anchors (not supplied)
4 - 5/8" Washer (found in parts bag) shims (if needed)
1.Place the air compressor on on a solid, level surface.
2.Mark the surface using the holes in the air compressor feet as a template.
3.Drill holes in the surface for the concrete anchors. Install concrete anchors.
3/8" Lag
Screw
(not supplied)
5/8" Washer (supplied)
Shim Under |
| Surface Line |
|
| |
|
| |
Washer | Concrete Anchor | |
(not supplied) | (not supplied) | |
3.
D24450 | 10- ENG |
