Craftsman 919.7243 Contents of Carton, Tools Required for Assembly Assemble Wheels, Unpacking

	ASSEMBLY
Contents of Carton
1 -	Air Compressor	Hose
2 -	Wheels
		Wrap
1 -	Hose Wrap
2 - Self Tapping Screws,		Self
	1/4-20x1.25
		Tapping
2 -	Shoulder Bolts, 3/8-16 x 3.40
		Screws
2 -	Hex Nuts, 3/8-16	DO NOT use hose
2 -	Rubber Feet	wrap as a handle to
2 -	Screws, 1/4-20 x .75	push, pull, or lift air compressor.
Tools Required for Assembly		Assemble Wheels

1 - 9/16" socket or open end wrench

1 - 1/2" socket or open end wrench

1 - 3/8" socket or standard screwdriver

Unpacking

1.Remove all packaging leaving the air compressor on the pallet.

2.Remove and discard the (4) screws holding the air compressor to the pallet.

Rubber

Feet

Screw

Nut

Wheel

Shoulder Bolt

Screws

It will be necessary to brace or support

one side of the air compressor when installing the wheels because the compressor will have a tendency to tip.

1.Attach wheels with shoulder bolts and nuts as shown.

It may be necessary to brace

or support one side of the air compressor when removing the pallet because the air compressor will have a tendency to tip.

3.Carefully remove the air compressor from the pallet.

Assemble Hose Wrap

1.Line up two bolt holes in saddle with holes in hose wrap as shown.

2.Install the self tapping screws through hose wrap and saddle.

3.Tighten securely. Be sure not to over-tighten.

2.Tighten securely. NOTE: The air compressor will sit level if the wheels are properly installed.

The wheels and handle do not

provide adequate clearance, stability or support for pulling the unit up and down stairs or steps. The unit must be lifted, or pushed up a ramp.

Assemble Rubber Feet

1.Attach rubber feet with the screws provided as shown in previous figure.

2.Tighten securely.

D26700 10- ENG