Cooling System (not shown): This compressor contains an advanced design cooling system. At the heart of this cooling system is an engineered fan. It is perfectly normal for this fan to blow air through the vent holes in large amounts. You know that the cooling system is working when air is being expelled.
Air Compressor Pump (not shown): Compresses air into the air tank. Working air is not available until the compressor has raised the air tank pressure above that required at the air outlet.
Check
Valve: When the air compressor
is operating, the check
valve is "open", allowing
compressed air to enter the air tank. When the air compressor reaches
Pressure Release Valve: The pressure release valve located on the side of the pressure switch, is designed to automatically release compressed air from the compressor head and the outlet tube when the air compressor reaches
be heard leaking when the motor is running or after the unit reaches "cut- out" pressure.
Hose Wrap: Conveniently stores up to 50 feet of air hose.
Hose Wrap
How to Use Your Unit
How to Stop:
1.Set the On/Auto/Off lever to "OFF".
Before First Start-up
Risk of Unsafe Operation. Serious
damage may result if the following
This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced.
1.Make sure the On/Auto/Off lever is in the "OFF" position.
NOTE: If quick connect is installed, pull coupler back until it clicks to prevent air from escaping through the quick connect.
2.Plug the power cord into the correct branch circuit receptacle. (Refer to Voltage and Circuit Protection paragraph in the Installation section of this manual.)
3.Open the drain valve fully (counterclockwise) to permit air to escape and prevent air pressure build up in the air tank during the
NOTE: Always drain tank on a washable surface or in a suitable container to prevent damaging or staining surfaces.
D26700 | 14- ENG |
