Cooling System (not shown): This compressor contains an advanced design cooling system. At the heart of this cooling system is an engineered fan. It is perfectly normal for this fan to blow air through the vent holes in large amounts. You know that the cooling system is working when air is being expelled.
Air Compressor Pump (not shown): Compresses air into the air tank. Working air is not available until the compressor has raised the air tank pressure above that required at the air outlet.
Check Valve: When the air compressor is operating, the check valve is
“open”, allowing compressed air to enter the air tank. When the air compressor reaches
pressure, the check valve “closes”, allowing air pressure to remain inside the air tank.
Pressure
Release Valve: The pressure release valve, located on the side of
the pressure switch, is designed to automatically release compressed air from the compressor head and the outlet tube when the air compressor reaches
Air Intake Filter (not shown): This filter is designed to clean air coming into the pump. This filter must always be clean and ventilation openings free from obstructions. See "Maintenance".
How to Use Your Unit
How to Stop:
1.Set the On/Auto/Off lever to “OFF”.
Before Starting
Break-in Procedure
Risk of Unsafe Operation. Serious
damage may result if the following
This procedure is required before the air compressor is put into service and when the check valve or a complete compressor pump has been replaced.
1.Make sure the On/Auto/Off lever is in the "OFF" position.
NOTE: If quick connect is installed, pull coupler back until it clicks to prevent air from escaping through the quick connect.
On/Auto/Off
PressureSwitch
Switch
Safety
Valve
Outlet
PressureTank
GaugePressure
Gauge
Regulator
Quick
Connect
D27610 | 14- ENG |
