ASSEMBLY

Tools Required for Assembly

1 - 9/16" socket or open end wrench

1 - 1/2" socket or open end wrench

Unpacking

1.Remove unit from carton and discard all packaging. NOTE: Save all parts bags.

Open End

Of Handle

Saddle Hole

To Install Handle

Bent Tabs

Handle Hole

The wheels and handle do not

provide adequate clearance, stability, or support for pulling the unit up and down stairs or steps. The unit must be lifted or pushed up a ramp. Do not lift the unit by the manifold assembly, the unit

could be damaged.

1.To make installation easier, submerge handle grip into warm soapy water. Remove handle grip from soapy water and slide onto handle.

2.Insert the open end of the handle under the saddle. Before attaching handle, you may have to pull the open ends of the handle apart so they fit tightly against the side of the saddle. Looking in from the open end of the saddle, position the handle toward the two bent tabs, on the inside walls of the saddle.

3.Slowly push the open ends of the handle onto both tabs at the same time. Continue pushing the handle into the saddle until the holes on the side of the saddle and handle are in line.

4.Guide the straight end of each retaining clip through the saddle hole and both handle holes.

5.Rotate each retaining clip and press down until it snaps into place over the handle.

Retaining Clip

Handle

Inserted

On Tabs

Retaining Clip Handle

Open End

Of Saddle

 

 

 

 

Open End

 

 

 

 

Bent Tabs

Saddle

Of Handle

A15256

10- ENG

Page 10
Image 10
Craftsman 919.728001, A15256 owner manual Tools Required for Assembly, Unpacking, To Install Handle