CARTONCONTENTS Checkcartoncontentsagainstthefol* lowinglist.
Model C944.511590
•Brushcutter Attachment
•Handlebar (with Clamp and Knob)
•Handlebar Clamp Base (with Spacer Tabs)
•Shoulder Strap
•Upper Shoulder Strap Clamp
•Lower Shoulder Strap Clamp (with Spacer Tabs)
•Clamp Screws (6)
•Attachment Hanger
•Hex Wrench
Examine parts for damage. Do not use damaged parts.
NOTE: If you need assistance or find that parts are missing or damaged, call
ASSEMBLY
_WARNING: If received assembled,
repeat all steps to ensure your unit is properly assembled and all fasteners
are secure,
*A hex wrench (provided) is required for assembly.
HANDLEBAR ASSEMBLY
DANGER: RISK OF CUT. To
avoid serious injury, the barrier portion of the handlebar must be installed as
shown on the upper tube of the power- head to provide a barrier between op- erator and the spinning blade. Attach tube clamp above arrow on safety warning decal on the upper tube (pow- erhead end of unit). Ensure handlebar is positioned on handlebar clamp be- tween the arrows on the handlebar de- cal.
NOTE: The tube clamp base has four spacer tabs attached. These tabs are provided to adapt this attachment for
use with powerheads that have a 1" diameter upper tube (the tube clamp
will not tighten down securely on the 1" diameter upper tube without using these spacer tabs). The tabs must be broken off completely before use and placed over the screw holes on the clamp base. These tabs are not need- ed for powerheads with a 7/8" upper tube.
HANDLEBAR CLAMP BASE
Spacer T_.._ ___1,4_
Spacer | Tabs | _ |
|
positioned for | _ | ||
on 1" | diameter |
| _._,_,,,_ |
upper | tube |
|
|
1, Place the tube clamp over the up- per tube above the arrow on the safety decal.
2.Position the clamp base under the upper tube and align the tube clamp and clamp base screw holes (use spacer tabs between tube clamp and clamp base if nec- essary to secure clamp, i.e. for 1" diameter upper tube).
Handlebar
POWERHEAD
END
between arrows on handlebar decal
Knob
ClampScrews
Arrow on
Safety Decal
ATTACHMENT
END
3.Insert four screws into the screw holes.
4.Secure tube clamp by tightening screws with the hex wrench.
5.Position the handlebar as shown, ensuring the handlebar is posi- tioned on the handlebar clamp be- tween the two arrows on the han- dlebar decal.