Craftsman pmn Assembly of Mitre Fence, Alignment of Back Fence to Mitre Fence Slot

Router Table for the Craftsman

Q.Assembly of Mitre Fence

1.Identify the components required, see opposite.

2.Insert the pin of the Mitre Fence Head into the Mitre Bar.

3.Insert the Securing Bolt and fit the Flat Washer and Securing Knob (small size).

4.Remove any flash on the plastic pointer with a sharp knife.

5.Position the pointer as shown in fig. Q.1 and insert the bolt, then fit the nut.

Alignment of Back Fence to Mitre Fence Slot

1.Measure the distance from each end of Back Fence to edge of Mitre Fence slot in the Table Surface as shown in fig. Q.2. Adjust the position of the Back Fence to ensure both distances are equal.

2.Position Mitre Gauge in slot as shown in fig. Q.2.

R.No-Volt Release Switch - NVRS/230V (Standard accessory on tables made from 1/3/97)

The No-volt Release Switch can be fitted to the table leg or workboard to provide easy access to On/Off buttons. Should the power be turned off at source, the router will not restart until the green start button is pressed. The switch is for use with 230 volt routers up to 1850 watts.

1.With the fixing kit supplied, mount the No Volt Release Switch on the right side of the router table using the holes already drilled.

Knob

Flat washer
Mitre fence head
	Knob
Mitre bar	Pointer
Securing bolt	Hex nut

fig. Q.1

fig. Q.2

to plug at

mains supply

to socket for

plug of router

fig. U.1

workboard

fig. U.2

-17-