Crate & Barrel Loop Three-Drawer Chest CLEANING AND CARE, cam covers, drawer back, drawer pull, black screws, glide screws, drawer bottom, silver screws, phillips head screwdriver

LOOP 3 DRAWER CHEST

9Slide drawer back into vertical slots at rear of drawer sides.

These holes at back

10Slide drawer bottom into slot at base of drawer sides

and drawer front. Make sure pilot holes are at the back of the drawer bottom as shown.

B

A

11A) Secure underside of drawer bottom to drawer back with 3 black screws. Secure, but do not over tighten with the phillips head screwdriver.

B) Fit drawer pull into position as shown and secure with 2 silver screws.

Repeat Steps 8 - 11 for remaining 2 drawers.

B

C

A B

12A) Fully extend drawer glides from assembled unit as shown.

B) Position drawer assembly and rest the drawer assembly on top of the tabs as shown. Attach each glide to drawer with

2glide screws as shown. Secure with a screwdriver. Repeat steps for each drawer.

C) Conceal all exposed cams with cam covers. Assembly is now complete.

CLEANING AND CARE

Clean surfaces with a dry or damp soft cloth. Do not use abrasive cleaners. Do not use furniture wax or polish as the wood is finished with a protective clear lacquer.

Made in China r08 Customer Service 800.967.6696 www.crateandbarrel.com Page 4 of 4