Crate Amplifiers owner manual GT-80D Front Panel, Overdrive Gains

GT-80DQuadraDrivetm

THE GT-80D FRONT PANEL:

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25

1:INPUT: Connect your guitar here using a shielded instrument cable.

OVERDRIVE Gains:

2:TUBE GAIN: This serves as the gain control for the Overdrive Channel’s Tube preamp section, giving you con- trol over the compression and overdrive characteristics of the GT-80DSP’s input tubes. Use this control along with the Overdrive Channel’s volume control (#15) to create a wide variety of sounds at any volume level. (Some sug- gested settings can be found on page 12.) With the control to the full-left position, no signal passes through. As you bring the control towards center you increase the signal level and the tube compression, with maximum tube distortion towards the full-right position.

3:OVERDRIVE LED: This LED glows red when the Overdrive Channel is chosen, and along with LED #14 gives you a visual sign that the Overdrive gains, tone controls and volume control are active.

4:SOLID STATE GAIN: This serves as the gain control for the Overdrive channel’s Solid Sate preamp section. Use this control along with the Overdrive Channel’s volume control (#15) to create a wide variety of sounds at any volume level. (Some suggested settings can be found on page 13.) With the control to the full-left position, no sig- nal passes through. As you bring the control towards center you increase the signal level and compression, reach- ing maximum distortion in the full-right position.

5:CHANNEL: Select either the Overdrive channel (switch in the IN position) or the Clean Channel (switch OUT) with this pushbutton switch. The channel indicator LEDs (#3 and 14 for Overdrive, #9 and 19 for Clean) work with this switch as a visual guide.

NOTE: When a footswitch is connected to the Channel Select footswitch jack (see #29, rear panel) the front-panel switch will have no control over which channel is selected.

6:TUBE/SOLID STATE: Select either the Tube preamp (switch IN) or the Solid State preamp (switch OUT) for either channel with this pushbutton switch. The Tube LED (#7) works with this switch as a visual guide: it glows when the tube section has been selected.

NOTE: When a footswitch is connected to the Channel Select footswitch jack (which also serves as the Tube/Solid State select; see #29, rear panel) the front-panel switch will have no control over which preamp section is select- ed.

7:TUBE LED: This tube-shaped symbol glows orange when the Tube preamp section is selected, giving you a quick visual reference as to which preamp section is active.

CLEAN Gains:

8:TUBE GAIN: This serves as the gain control for the Clean Channel’s Tube preamp section, giving you control over the compression and overdrive characteristics of the GT-80D’s preamp tube. Use this control along with the Clean Channel’s volume control (#20) to create a wide variety of sounds at any volume level. (Some suggested settings can be found on pages 12 and 13.) With the control to the full-left position, no signal passes through. As you bring the control towards center you increase the signal level and the tube compression, with a bluesy tube crunch coming to life as you approach a setting of 8 and thicker tube distortion in the full-right position.

4