The Rear Panel
D E S I G N E D I N S T . L O U I S M O , U S A . M A N U FA C T U R E D I N | C H I N A , FA B R I Q U E E N C H I N E | |
c 2 0 0 7 L O U D T E C H N O L O G I E S | I N C | |
|
| |
|
|
R E V E R BL I N E O U TS P E A K E R
1112
IN OUT
8Ohms
SERIAL NUMBER |
| |
| ||
| C | US |
3031613
CONFORMS TO
MANUFACTURING DATE | IEC 60065 |
|
N222
115 |
AVIS: RISQUE DE CHOC ELECTRIQUE — NE PAS OUVRIR
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. DO NOT REMOVE COVER. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED PERSONNEL.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including13 1415 16 interference that may cause undesired operation.
11.AC LINE CORD: The grounded power cord should only be plugged into a grounded power outlet that meets
all applicable electrical codes, and is compatible with the voltage, power, and frequency requirements stated on the
12.Voltage Select Switch: Set this switch to “115” for 120 VAC mains, and to “230” for
With the amplifier power cord unplugged, use the tip of a small flat- blade screwdriver to slide this switch to the proper position.
13.REVERB IN Jack: The V18 is shipped with a cable connected from this jack to the input of the internal spring reverb.
14.REVERB OUT Jack: The V18 is shipped with a cable connected from this jack to the output of the internal spring reverb.
15.LINE OUT: Use this 1/4" TS jack to send the signal from the preamplifier stage of the V18 to a mixer or recorder. The signal comes after the EQ stage but before the reverb stage.
16.SPEAKER 8 OHMS: The V18 is shipped with a cable connected from this jack to the internal speaker(s).
5
