View of Controls
Diagram D
No Controls Models –
These models can be installed in association with a separate room thermostat control.
Bracket release for cleaning
For safety, the heater should be switched off at the mains before proceeding. To release the panel heater from the bracket, the rear catch must be pressed down while pulling the heater forward gently. It is recommended to use a narrow tool for this purpose. A pencil or small screwdriver would be a suitable tool. Diagram D shows the procedure for releasing the heater from the bracket.
When replacing the heater on the bracket, firstly engage the heater on to the bottom hooks and then press the heater on to the catch. It is recommended to press the heater at the ends and not to the grille area.
