Care and Cleaning

Cleaning materials to avoid

Ceramic hob

Grill

Control Panel

Decorative Trims

TURN OFF THE MAIN SWITCH BEFORE CLEANING.

BEFORE SWITCHING ON AGAIN, ENSURE THAT ALL CONTROLS ARE IN THE OFF POSITION.

NEVER USE BIOLOGICAL WASHING POWDER, HARSH ABRASIVES, SCOURING PADS, AEROSOL CLEANERS OR OVEN CHEMICAL CLEANERS OF ANY KIND UNLESS

SPECIFIED BELOW.

1.Plastic or nylon pads / scourers, these may scratch the surface.

2.Household abrasive powders.

3.Oven chemical cleaners, aerosols and oven pads.

Caustic cleaners such as these will etch the surface and attack the metal frame.

4.Bath and sink cleaners may mark the surface.

To reduce the amount of cleaning always ensure that the hob and cook- ing utensils are clean and dry before use. Regular use of cleaner condi- tioner is recommended for proper care and protection of the hob sur- face. Apply conditioner before using the hob for the first time. It contains a mild cleaning agent, so that subsequent applications may clean off soil and apply a protective film at the same time. For stubborn stains or heavy soiling use any of the following materials, and finish off with con- ditioner.

1.Cif, non-scratch scouring cream.

2.Liquid Gumption Kitchen Cleanser.

3.Special Powder Cleanser.

Powder Cleanser – Mineral deposits that are present in hard water, and some foods, may cause ‘discolourations’ that appear in the form of grey or brown stains. The stains sometimes appear to be in or under the glass surface. If there are some persistent stains after using any of the other recommended cleaning materials, powder cleanser may be applied, fol- lowing the manufacturers instructions. Do not use abrasive cleaners or the powder cleanser on the painted metal framework.

Cleaner Conditioner – Regular use of the conditioner will make the sur- face easier to clean thus ensuring that years of heavy abrasive cleaning do not progressively dull the surface.

Remove the grill pan and the wire grid food support, it is best to wash these items immediately after use to prevent stains from being burnt on when used again. Wipe out the Grill compartment, use a fine steel wool soap pad to remove stubborn stains from the grill runners the grill deflector plate and the floor of the compartment.

Wipe over the control panel with a damp cloth and polish with a dry cloth. Do not use cream cleaners, oven cleaners or aerosols, scouring pads or abrasive powder for cleaning the plastic knobs as damage will occur.

It is advisable to clean the decorative trims regularly to prevent any build up of soiling. The recommended method of cleaning is to wipe over the trims with a soft cloth wrung out in hot water or mild non-abrasive cleaner. (If in doubt try the cleaner on a small area of trim which is not noticeable in normal use). Then, after wiping with a cloth wrung out in clear water, dry with a soft clean cloth.

27

Page 27
Image 27
Creda X155E manual Care and Cleaning, Ceramic hob Grill Control Panel Decorative Trims