Crestron electronic AM/FM/TV Tuner Setup

8 •• Integrated AM/FM/TV Tuner: ST-TUNE Operations Guide - DOC. 5833A

NOTE: Equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. The equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

n Reorient or relocate the receiving antenna.

n Increase the separation between the equipment and receiver.

n Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

n Consult the dealer or an experienced radio/TV technician for help.

As of the date of manufacture, this unit has been tested and found to comply with

specifications for CE marking.

Setup

CAUTION: Crestron modular cables are rated for a maximum of two (2) amperes.

Do not exceed this current capacity for any modular device. If more current is

required, connect an appropriate external power pack to the device.

NOTE: If making category 5 connections to the Cresnet peripherals, refer to the

latest revision of the Cresnet Mini Network CAT 5 Interconnect Drawing (Doc.

5819). This document can be obtained from the Products page (PRODUCT

MANUALS, Software and Wiring Diagrams section) or Downloads page (CABLES

and MANUAL Libraries, search for CAT5.PDF) of Crestron’s website

(www.crestron.com). New users are required to register to obtain access to the FTP

site.

NOTE: Review the latest revision of the Network Modular Cable Requirements

(Doc. 5682). This document can be obtained from the Products page (PRODUCT

MANUALS, Software and Wiring Diagrams section) or Downloads page (CABLES

and MANUAL Libraries, search for MODULAR.PDF) of Crestron’s website

(www.crestron.com).

NOTE: The CNHBLOCK should be used when wiring multiple Cresnet devices to

a system. Use only Crestron modular cables when making connections to the

CNHBLOCK modular ports. DO NOT use standard, modular 6-conductor telephone

cables. Most telephone cables are wired in a crisscross fashion and are not

compatible with Crestron equipment.