Crimestopper Security Products CS-2002DC SERIES III manual Programmable Option Reset

PROGRAMMABLE OPTION RESET

Follow the steps below to reset ALL OPTION VALUES ON PAGE 10 TO FACTORY DEFAULT SETTINGS.

1.Turn the Ignition ON and press the Override/Program button 5 times. You should hear a long chirp.

2.Immediately press Button #3 (Trunk) on the remote.

3.The siren will chirp 4 times and lights will flash 4 times.

4.Turn off ignition and all programming options should be restored to * values. (See page 10)

CUSTOM PERSONAL OVERRIDE CODE

Custom override allows the user to set a specific number of button presses (2-15) required to perform an emergency override/disarm of the alarm system. This increases the level of security of the system, but you MUST MEMORIZE how many button presses you have changed your system to use or the unit will not disarm in an emergency.

1.Enter programming mode. (See step #1 on page 10)

2.Press program button three times to go to option #3 “Passive Locks/Custom Override”.

3.Press the Button #3 (TRUNK) on the remote transmitter.

4.Press and release the program again the number of times you desire in order to perform emergency disarm on this alarm system. Press the program button 2-15 times only.

To test feature: Trip alarm system, turn key ON, press the program/valet button 2-15 times as programmed above then continue to HOLD DOWN valet button on the LAST PRESS for 5 seconds. Alarm should disarm. If system does not disarm, then disarm with the remote transmitter and try again. If system still does not disarm, then repeat steps above.