Crimestopper Security Products CS-2002DC SERIES III manual Transmitter Programming, Diagram

TRANSMITTER PROGRAMMING

This system will learn a maximum of 4 transmitters.

1.Turn Ignition ON/OFF…ON/OFF …ON. You should hear (3) chirps.

2.Press the Program/Override Button 5 times and you should hear 5 light flashes and 5 siren chirps. (System is now in transmitter programming mode.)

3.Press and release Button #1 on the remote. The siren will chirp once. Press Button #1 AGAIN, you should hear 2 chirps on the second press for code-learn confirmation. Sometimes it takes a 3rd press to get the remote to learn.

4.Repeat step #3 for up to 3 additional transmitters, or turn Ignition OFF. Siren will chirp 3 times and lights will flash 3 times when exiting the transmitter programming mode.

Note: If you are using CS-2002DC III identical alarms system in two vehicles, you can program button 4 (PANIC) from YOUR remote to ARM/DISARM the OTHER vehicle’s alarm. Follow steps above at the OTHER vehicle, except press YOUR remote Button #4 (PANIC) 2 times in step #3 above. The other vehicle’s alarm will learn YOUR Button #4 (PANIC). You can only ARM/DISARM the second vehicle. You cannot perform any other special or auxiliary functions on car #2.

DIAGRAM:

	IGN	TURN IGN. ON	5 CHIRPS
		3 TIMES:
		ON, OFF
		ON, OFF	PRESS
OFF		ON.
			BUTTON
			5 TIMES
			5 FLASHES

IGN

PANIC

1st = 1 CHIRP	LEARN
	ANOTHER OR
2nd = 2 CHIRPS
	REMOTE
(CODE LEARNED)	OFF

PRESS LOCK BUTTON 2 X's

3 CHIRPS