Crimestopper Security Products CS-2012DP-TW1 manual Wiring 6-PIN High Current Connector

WIRING: 9-PIN Connector

STARTER DISABLE:

	IGN. SWITCHED	IGNITION SWITCHED
		"ON" & HOT THROUGH
		CRANKING
	STARTER WIRE
CONNECT TO		CUT
	YELLOW
ORANGE WIRE
OF ALARM		STARTER
PRE-WIRED
STARTER DISABLE	BLUE
RELAY & SOCKET	ORANGE	MAKE CERTAIN TO
	ORANGE
		CONNECT BROWN
START OUTPUT		WIRE TO STARTER
		MOTOR SIDE!!!
FROM ALARM	BROWN
6-PIN HARNESS

Orange/Black: (-) OEM Disarm Output

This wire provides a Ground pulse to disarm vehicles' Factory anti-theft system prior to a Remote Start. Connect this wire to the vehicles' anti-theft disarm wire. This wire is sometimes found coming off the Driver's door key switch or at the Factory Anti-theft control module.

WIRING: 6-PIN High Current Connector

\
PIN 1: BROWN:	STARTER OUTPUT (30A Max.)
PIN 2: GRAY:	ACCESSORY (HEAT/AC) (30A)
PIN 3: RED:	+12V POWER INPUT (BATTERY) FUSED (30A)
PIN 4: RED:	+12V POWER INPUT (BATTERY) FUSED (30A)
PIN 5: PINK:	IGNITION 1 (30A Max.)
PIN 6: PINK/WHITE:	START 2, IGN 2, ACC 2 OUTPUT (30 Max.)

NOTE!: Use External Relays for High Current Ignition and/or Accessory circuits greater than 30A. Failure to do so could result in damage to the unit that is not covered under warranty.

6