Crimestopper Security Products CS-2012DP-TW1 manual Wiring 4-PIN Shock Sensor 22 Gauge wires

WIRING: 2-PIN LED / 2-PIN Program-Valet Button (22 gauge wires)

Mount LED in a visible location on the Dash or Console. Connect the small 2-pin plug from the LED to the control module. Note: Connectors are designed so that they will only plug into their appropriate slots.

Mount the Valet/Program/Override button in a suitable location. Connect the 2-pin plug from the Switch to the control module. Note: Connectors are designed so that they will only plug into their appropriate slots.

WIRING: 4-PIN Shock Sensor (22 Gauge wires)

Sensor Adjustment

Adjust the main shock sensor with the small White dial. Clockwise will increase sensitivity and counter-clockwise will decrease sensitivity. Adjust Pre-Warning level with small Black dial.

TRIGGER (WHITE KNOB)	GREEN LED (Pre-Warn)
PRE-WARN (BLACK KNOB)	RED LED (Trigger)

(-) TRIGGER WHITE

(-) PRE-WARN BLUE

GROUND BLACK

12 VOLTS RED

SHOCK SENSOR: The sensor supplied with this system does not require any additional wiring. Simply mount the sensor in a suitable location, plug it in, and adjust for sensitivity.

10