FUNAI CMWC13D6 Connecting to AN External Device Front, Installing the Batteries in Remote Control

CONNECTING TO AN EXTERNAL DEVICE (FRONT)

When you watch a program recorded on another source (VCR or video camera), use the AUDIO/VIDEO input jacks on the front of the unit.

Connect the Audio/Video output jacks of another source to the AUDIO and VIDEO jacks of this unit.

STANDBY-ON OPEN/CLOSE

VIDEO AUDIO

VOLUME	CH. STOP	PLAY
	SELECT

FOR USE

ex.

VCR or video camera, etc.

[Front of the unit]

	To the Audio output jack
(OUT)	Audio Cable		(IN)
	(commercially available)	OPEN/CLOSE
		VIDEO	AUDIO
	To the Video output jack		(IN)
(OUT)	Video Cable
	(commercially available)

AUX

PREPARATION

Then use [SELECT] or [CH. K / L] until "AUX" appears on the screen. (Refer to "TO WATCH EXTERNAL INPUT" on page 9.)

INSTALLING THE BATTERIES IN REMOTE CONTROL

1)Open the battery compartment cover by pressing the cover on the remote unit in the direction of the arrow.

2)Insert 2 "AA" penlight batteries into the battery compartment in the direction indicated by the polarity (+/-) markings.

3)Replace the cover.

1 2 3

[BATTERY PRECAUTIONS]

•Be sure to follow the correct polarity as indicat- ed in the battery compartment. Reversed batter- ies may cause damage to the device.

•Do not mix different types of batteries together (e.g. Alkaline and Carbon-Zinc) or old batteries with fresh ones.

•If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from possible battery leakage.

•Do not try to recharge batteries not intended to be recharged; they can overheat and rupture.

7

EN