Turntable Operation
Turntable Features
1Selectable 33/45/78 rpm speeds.
2Load up to 6 records at a time.
3Plays 7”, 10”, and 12” records.
4Record changer is fully automatic or can be operated manually.
5Adjustable tone control.
Turntable Instructions
1Turn power on by rotating the ON/OFF VOLUME KNOB (10) clockwise.
2Lift TENSION ARM (1) and rotate
3Load desired records on the CENTER SPINDLE
(2). Records should be loaded one at a time.
4Lift TENSION ARM (1) and rotate it clockwise over the records and release. TENSION ARM (1) will automatically pull down onto the records.
5Set the SIZE SELECT SWITCH (6) to the correct size of your records.
6Set the SPEED SELECT SWITCH (4) to the correct speed of your records.
7Move the TURNTABLE SWITCH (8) to the “ON” position. Turntable will begin to turn.
8. Remove white protective needle cover by gently pulling towards the front of the unit.
9Move the TURNTABLE SWITCH (8) to “AUTO”. The switch will automatically return back to the “ON” position and the first record will drop. The TONE ARM (5) will automatically lift and move to the beginning of the record. Once the first record is finished, the TONE ARM (5) will move back to the TONE ARM REST (7) and the next record will drop. The TONE ARM (5) will move back to the beginning of the record. This will repeat until the last record is finished. When the last record is finished, the TONE ARM (5) will return to its rest and the turntable will shut off.
10 To manually switch to the next record during playback, move the TURNTABLE SWITCH (8)
6
to the “AUTO” position. The next record will drop and begin to play.
11 To stop playback manually, move the TURNTABLE SWITCH (8) to the “OFF” position. Gently lift the TONE ARM (5) from the record and return it to the TONE ARM REST (7).
12 To remove the records from the turntable, lift the TENSION ARM (1) up and rotate it counter- clockwise over the TONE ARM (5). Grab the edges of the bottom record and lift straight up.
Tone Arm Adjustment
1
2
Do not turn
3
1Adjust this screw if the TONE ARM(25) is not raising high enough to clear to the TONE ARM REST(27). Turn the screw
2Adjust this screw if the TONE ARM(25) drops on the record too early or too late. Turn the screw
3Adjust the screw if you feel there is not enough tone arm pressure on the record. Turn the screw
Note : Adjust the screws one turn at a time and check the adjustment after each turn.
Welcome
Thank you for purchasing the Crosley 1950’S Stack-
About This Manual
Instructions in the manual describe the controls and functions of the CR89.
Table of Contents
Getting Started |
|
Control Locators | 4 |
Unpacking | 5 |
Set Up | 5 |
Power Source | 5 |
Turntable |
|
Turntable Features | 6 |
Operating Instructions | 6 |
Tone Arm Adjustment | 6 |
Accessory: Adapter for 45 rpm |
|
.................................................... | 7 |
Tone Control | 7 |
General |
|
Troubleshooting Guide | 7 |
Warranty | 8 |
