WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER. PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
General
Troubleshooting
There’s no sound?
The lighting flash with arrowhead symbol, within an equilateral triangle, is intended to alert user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute risk of electric shock
to persons.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER - SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
The exclamation point within an equilateral triangle is intended to alert user to the presence of important operating and maintenance (servicing) instruction in the literature accompanying the appliance.
1
2 Check that the volume is turned up by pressing vol.+ button on remote.
3 Make sure ext. / int. /mix. switch on back of radio is on “int.” or “mix.”.
(unless you are using external speakers, in which case it should be on “ext.”.)
4 Check to make sure power is turned on.
CD does not play?
1 Check to make sure CD is inserted correctly (label side facing up).
“Ventilation not to be impeded.”
“Do not expose to moisture or liquids. Do not place objects filled with liquids, such as vases, on the apparatus. “
Specification
FREQUENCY | : | FM 87.5 |
|
| AM 525 - 1710 KHz |
POWER SOURCE | : | AC120V~60Hz |
ANTENNA | : | EXTERNAL 300 Ohm ANTENNA FOR FM |
| : | |
POWER CONSUMPTION | : | 110W |
AUDIO POWER OUTPUT | : | 18W x 2 |
SPEAKER OUTPUT | : | 18W |
SPEAKER | : | 6 1/2” Dynamic type x 2 |
| : | 4ohm 40watt |
| : 2 1/2” Tweeter type x 2 | |
| : | 8ohm 10watt |
*DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
2 Check to see that surface of CD is clean.
3 Make sure radio is on CD function by pressing CD / Radio button.
Remote not working?
1 Replace batteries.
2 Be sure and point remote towards remote sensor when using.
3 Remove obstacles in the path of the remote and the radio so that remote signal has a straight path to the radio.
11
