Commercial Audio Series Business Music System
2 Setup
2.5 WireYour System
Typical input and output wiring is shown in Figure 2.11.
INPUTS: Connect microphones or balanced
OUTPUTS: Maintain proper polarity
Connect the Amplifier Output screw terminals to loudspeakers. Use terminals marked COM and 25V or 70V for
Connect the COM terminal to speaker negative
2.6 Phantom Power
Condenser mics require phantom power to operate. If you are using a condenser microphone with the 180MAx on Input 1, turn on the Phantom Power Switch on the back of the
2.7 Link In/Out Switch
This switch (Figure 2.11) affects which signals are heard when another mixer is wired to the
IN: Any signal applied to the AMP INPUT connector will be mixed with the input signal(s).
OUT: Only the signal from the AMP INPUT connector will appear at the amplifier output.
How to link another mixer to your mixer-amplifier:
Connect the extra mixer’s LINE OUT connector to the
How to set up Music-On-Hold output:
Connect
How to set up a processing loop:
Connect
CD/DVD player
Satellite receiver
70V speakers
(four JBL Control 1ST speakers supplied only with 180MAx Pack)
CONNECT 70V SPEAKERS
OR
BUT NOT BOTH.
XM antenna
One
or two 8-ohm speakers in parallel
Figure 2.10 Input and Output Wiring
Figure 2.11 Link In/Out Switch
Operation Manual | page 11 |