Crown Audio CE Series Specifications, 120 VAC, 60 Hz Units, Bridge mono mode, page, Performance

		CE Series Power Amplifiers
7 Specifications
Minimum Guaranteed Power	CE 1000	CE 2000
120 VAC, 60 Hz Units, Stereo mode, per channel, both channels driven
1 kHz with < 0.5% THD
2 ohms	560 W	975 W
4 ohms	450 W	660 W
8 ohms	275 W	400 W
120 VAC, 60 Hz Units, Bridge mono mode
1 kHz with 0.1% THD
4 ohms	1,100 W	1,950 W
8 ohms	900 W	1,320 W
Performance	CE 1000	CE 2000
Frequency Response (at 1 watt, 20Hz - 25 kHz)	± 0.2 dB	± 0.2 dB
Phase Response (at 1 watt, 20Hz - 20 kHz)	± 15°	± 15°
Signal to Noise Ratio below rated power (20 Hz to 20 kHz)	> 100 dB	> 100 dB
Total Harmonic Distortion (THD) at rated power, from 20 Hz to 20 kHz	0.5%	0.5%
Intermodulation Distortion (IMD) 60 Hz and 7 kHz at 4:1,
from 163 milliwatts to full bandwidth power	< 0.1%	< 0.1%
Damping Factor: 10 Hz to 400 Hz	> 400	> 400
Crosstalk (below rated power, 20 Hz to 20 kHz)	> 55 dB	> 55 dB
Common Mode Rejection (CMR) (20 Hz to 1 kHz)	> 70 dB	> 70 dB
DC Output Offset (Shorted input)	±10 mV	±10 mV
Input Impedance nominally balanced, nominally unbalanced	20 k ohms, 10 k ohms	20 k ohms, 10 k ohms
Load Impedance (Note: safe with all types of loads)
Stereo	2, 4 and 8 ohms	2, 4 and 8 ohms
Bridge Mono	4 and 8 ohms	4 and 8 ohms
Voltage Gain (at maximum level setting, to 1-kHz, 8-ohm rated output)
26 dB setting	26 dB	26 dB
1.4V setting	30.5 dB	32.1 dB
Required AC Mains (configured country-specific)	50/60 Hz, 100 - 240 VAC	50/60 Hz, 100 - 240 VAC
Power Draw at Idle	90 watts	90 watts
Cooling	Proportional speed fan	Proportional speed fan
Dimensions: Width, Height, Depth	EIA Standard 19 in. (48.3 cm) x 5.25 in. (13.34 cm) x 12.25 in. (31.11 cm)	EIA Standard 19 in. (48.3 cm) x 5.25 in. (13.34 cm) x 12.25 in. (31.11 cm)
Net Weight, Shipping Weight	32.6 lb (14.79 kg), 38.6 lb (17.49 kg)	40.3 lb (18.28 kg), 46.4 lb (20.98 kg)

page 22 Operation Manual