D Series Power Amplifiers
2 Setup
2.1 Unpack Your Amplifier | 2.2 Install Your Amplifier | 2.3 Ensure Proper Cooling |
Please unpack and inspect your amplifier for any damage that may have occurred during transit. If damage is found, notify the transportation company immediately. Only you can initiate a claim for ship- ping damage. Crown will be happy to help as needed. Save the shipping carton as evidence of damage for the shipper’s inspection.
We also recommend that you save all packing mate- rials so you will have them if you ever need to trans- port the unit. Never ship the unit without the factory pack.
YOU WILL NEED (not supplied):
•Input wiring cables
•Output wiring cables
Rack for mounting amplifier (or a stable surface for stacking)
WARNING: Before you start to set up your amplifier, make sure you read and observe the Important Safety Instructions found at the beginning of this
manual.
CAUTION: Before you begin, make sure your amplifier is disconnected from the power source, with the power switch in the “off” position and all level controls turned com- pletely down (counterclockwise).
Use a standard
You may also stack amps without using a cabinet.
NOTE: When transporting, amplifiers should be supported at the front.
When using an equipment rack, do not mount units directly on top of each other. Allow some air space between units for convection cooling. The side walls of the rack should be a minimum of two inches (5.1 cm) away from the amplifier sides, and the back of the rack should be a minimum of four inches (10.2 cm) from the amplifier back panel.
Figure 2.2 illustrates D Series amplifier installation.
Figure 2.2 Installation
Figure 2.1
page 6 | Operation Manual |
