3 Operation
3.3Back Panel Controls and Connectors
G. Power Cord
120 VAC, 60 Hz units have a
H. Reset Switches
The reset switches are used to reset the break- ers that safeguard each power supply from overload.
I. PIP Module
The standard
used in place of the
Input Sensitivity Switch
The
J. Balanced Phone Jack Inputs
Balanced
balanced (tip, ring and sleeve) or unbalanced (tip and sleeve) input signals. Because they are electrically in parallel with the PIP input con- nectors, input signals should not be connected to the phone jacks when certain PIP modules are installed (see the Crown Amplifier Applica- tion Guide availabel online at www.crownau- dio.com). The phone jacks can also be used as “daisy chain” outputs to simplify connecting input signals to multiple amplifiers.
K. Ground Lift Switch
This switch isolates or “lifts” the phone jack signal grounds from the AC power ground. Activating the switch inserts an impedance between the sleeve of each phone jack and the unit’s AC ground to help prevent the hum that can result from a ground loop.
L. Balanced XLR Inputs
The
Because the
M. Output Jacks
A pair of versatile
Figure 3.2 Back Panel
Controls and Connectors
Operation Manual | page 13 |