3 Setup
3.1Unpack Your Amplifier YOU WILL NEED (not supplied):
•Input wiring cables
•Output wiring cables
Rack for mounting amplifier (or a stable surface for stacking)
WARNING: Before you start to set up your amplifier, make sure you read and observe the Important Safety Instruc- tions found at the beginning of this man- ual.
3.2 Install Your Amplifier
CAUTION: Before you begin, make sure your amplifier is disconnected from the power source, with power switch in the “off” position and all level controls turned completely down (counterclock- wise).
Use a standard
You may also stack amps without using a cabi- net.
NOTE: When transporting, amplifiers should be supported at both front and back.
3.3 Ensure Proper Cooling
When using an equipment rack, mount units directly on top of each other. Close any open spaces in rack with blank panels. DO NOT block front or rear air vents. The side walls of the rack should be a minimum of two inches (5.1 cm) away from the amplifier sides, and the back of the rack should be a minimum of four inches (10.2 cm) from the amplifier back panel.
Figure 3.2 illustrates standard amplifier airflow.
POWER
ODEP
CH1 | CH2 | OFF |
| 3.5 in |
| ||||
|
8.9 cm
19 in
48.3 cm
SIDE VIEW
16 in
40.6 cm
Figure 3.1 Mounting Dimensions
Figure 3.2 Airflow
page 6 | Operation Manual |
