Engine Pulley
Shoulder Bolt
Figure 18
Auger Belt
•Remove the cotter pin and washer from the ferrule in order to disconnect the auger idler rod from the brake bracket assembly as shown in Figure 19.
•Slip the auger control belt (the front belt) off the engine pulley. See Figure 19 .
•Pull the brake bracket assembly towards the cable guide roller and unhook the auger cable “Z” fitting.
•Remove the upper bolts and lock washers which attach the auger housing assembly to the frame assembly using a 9/16” wrench. Refer to Figure 17.
Engine
Pulley
Auger | Auger |
Control | |
Idler | Belt |
Rod |
|
Ferrule |
|
Brake |
|
Bracket |
|
Assembly | Cable |
| Roller |
“Z” | Guide |
| |
Fitting |
|
Figure 19
•Separate the auger housing from the frame assembly by tilting the housing forward and pulling up the handles.
•Using a 1/2” wrench, remove the hex screw and belleville washer from the center of the pulley on the auger housing. Lift the brake bracket assembly out of the pulley groove and remove the pulley. See Figure 20. Be careful not to lose the key.
•Remove and replace auger belt inside belt keepers.
•Reassemble pulley to auger housing with hex screw and belleville washer (cupped side toward the pulley). Make sure key is in place on shaft and brake puck is seated in the pulley groove.
•Reassemble the belt cover and chute directional control.
Proper Adjustment: With the auger clutch lever in the disengaged position the top surface of the new belt should be even with the outside diameter of the pulley.
•To adjust, disconnect ferrule from brake bracket assembly and thread ferrule in (towards idler) to increase tension on belt, and out to decrease tension.
NOTE: The brake puck must always be firmly seated in the pulley groove when the auger control is in the disengaged position.
Auger Belt
Brake Bracket Assembly
Idler Pulley
Auger Pulley |
Belt Keepers | Hex Screw | |
Belleville Washer | ||
|
Figure 20
Drive Belt
•Unhook the extension spring from the belt cover plate. See Figure 21.
•Remove drive belt from the engine pulley and bottom drive pulley. Refer to Figure 21.
•Replace belt and reassemble in reverse order.
•Reassemble the two halves of the unit hooking the lower portion of the auger housing over the stationary shoulder bolts in the frame assembly.
•Secure the two halves with the two bolts and lock washers removed earlier. Refer to Figure 17.
15
