ure 5). You may also need to adjust the Deck Links (See Figure 5).
Deck Lift Spring inner nut
Figure. 5 | Deck Links |
d.Lower the mower deck to the cutting posi- tion. With a wrench loosen the inner rear nut on the Deck Lift Spring Assist. To adjust the deck up or down, use a wrench and with a few turns, adjust clockwise or counter clockwise the outer rear nut of the Deck Lift Spring Assist. Repeat this proce- dure on the opposite side of the Mower. Once the deck is adjusted, retighten bolts.
e.With the deck still in the cutting position, adjust the Deck Links. With a wrench loosen the top inner bolt of the Deck Link. To adjust the side of the deck up or down turn the top bolt clockwise or counter clockwise a few turns. Adjust both front and rear Deck links as necessary. Retighten nuts.
f.Raise the mowing deck to the transport position using the upper foot pedal.
g.Use the second foot pedal to lower the mowing deck to the cutting position and repeat step “b.” above to make sure that the desired cutting height has been attained. If the dimensions are not correct, repeat steps “c.” through “f.” above.
5.Lubricate all fittings listed in the mainte- nance section.
D.Zero Turn Break-In And Operating Procedures
DANGER:
Reread the “When Mowing” Safety Precautions.
The following procedures are suggested for opera- tors of
1.Orientation:
a.Read the entire Operator’s Manual.
b.Sit on the machine, adjust the seat before-
c.Become familiar with all of the machine controls, instrumentation, safety and instruction signs, and safety devices.
d.Move (or have moved) the machine to a safe, level area with no obstructions includ- ing objects, pedestrians, and animals.
2.Initial Operation:
a.Use protective equipment for eyes, hands, hearing, feet, legs, head and other areas of the body if needed — safety eye glasses, gloves, earplugs, boots, hats, etc.
WARNING:
Hearing Protection is required for all operator exposure exceeding two (2) hours.
b.Ensure that the area is free of animals and bystanders, especially children!
c.Survey the area where the equipment is to be used to make sure it is free of debris, sticks, stones, wires, bones, and other for- eign objects which could cause injury to bystanders, damage to the machine, or damage to nearby facilities.
d.Inspect the machine to make sure:
1.All guards, shields (including mower chute deflector) are in their proper place, are secure, and are functional.
2.That there are no spilled or leaking fuel or oil sources, nor loose fuel or hydraulic tank caps, hoses or fittings.
3.That there are no loose or missing hard- ware nor any missing items.
4.That no
5.That all safety signs and decals are properly installed and legible.
e.This is a one person machine, operator only! Riders are not permitted under any circumstance!
f.To start the engine on the machine:
1.Make sure the park brake is set to the “ON” position, both lap bars are in the neutral/start position, and the Power Take Off (PTO also referred to as blade control switch) is in the “off” (down) posi- tion.
2.Move the choke control forward and the engine speed control (throttle) forward (half way).
Note: E.F.I. Tanks do not have a choke control.
3.Insert the ignition key, turn the switch toward the
14
